2-Flute Downcut — 1/8"
Generic
Overview
Generic 2-flute downcut spiral end mill, 1/8in shank. Smaller diameter downcut for detail work on decorative surfaces and fine sign lettering where top-face quality matters. Max RPM: 30,000.
Properties
Difficulty
beginner
Pros
- Downcut spiral for clean top edges
- 1/8 inch fits most compact CNC routers
- Good for detail work
- Less splintering on top surface
- Affordable
Cons
- Thinner shank = more deflection
- Not for aggressive cuts in hard material
- Poor chip evacuation in deep pockets
- Can break if feed rate is too aggressive
Best For
- Fine lettering on decorative surfaces
- small detail cuts on veneered panels
- painted MDF signs
Avoid For
- Deep cuts
- any application without chip evacuation at base
- large material removal
Brands
WhitesideAmana ToolCMTSpeTool