Longer Ray5 20W — Bare Aluminum (with spray)
Notes
Diode cannot mark bare aluminum - 450nm reflects off bare metal. Marking spray required.
Tips
Apply Cermark or LaserBond 100, let dry 60s, engrave, wash off.
Details
Diode cannot mark bare aluminum - 450nm reflects off bare metal. Marking spray required.
Setup
| Setting | Value |
|---|---|
| Preparation | Apply Cermark or LaserBond 100 - let dry 60 seconds |
Engraving
| Setting | Value |
|---|---|
| Engrave With Spray | 400 mm/min @ 100% x1 |
Settings
| Setting | Value |
|---|---|
| Finish | Wash off marking compound with water |
Safety
| Setting | Value |
|---|---|
| Note | Diode CANNOT mark bare metal without coating |
Tips
Apply Cermark or LaserBond 100, let dry 60s, engrave, wash off.